Skip to main content
    Book Your Install Now
    Titan Barriers
    Fixed steel bollards permanently installed in concrete protecting a commercial building entrance in Edmonton Alberta
    Bollard Installation

    Fixed & Embedded Bollard Installation

    Permanent, embedded steel bollards that stop vehicles — not just redirect them. Alberta's most common and cost-effective bollard type for commercial properties. Titan installs fixed bollards across Edmonton, Calgary, Red Deer, and Lethbridge.

    Specialized Protection

    Fixed Bollards

    Fixed bollards are permanently embedded in concrete footings and cannot be removed, retracted, or repositioned once installed. They represent over 99% of the bollards Titan installs across Edmonton, Calgary, Red Deer, and Lethbridge because they offer the highest strength-to-cost ratio of any vehicle barrier system. When a commercial property needs reliable, maintenance-free protection against vehicle intrusion, fixed bollards are the default choice for good reason.

    350+

    Colour Options

    100%

    Full-Service Install

    Fixed steel bollards permanently installed in concrete protecting a commercial building entrance in Edmonton AlbertaTitan Barriers

    What We Install

    Fixed Bollards Bollard Solutions

    These are the same bollards you see protecting daycares and childcare centres, banks and financial institutions, retail storefronts, industrial and warehouse facilities, healthcare and medical buildings, faith-based facilities, parking lots, and government and municipal buildings across Alberta. Fixed bollards are the workhorse of commercial property protection.

    Storefront Fixed Bollards

    Permanent steel bollards protecting retail storefronts, strip malls, and commercial building frontages against ram-raids and accidental vehicle strikes.

    Entrance & Walkway Bollards

    Fixed bollards flanking entrances, pedestrian walkways, and gathering areas to create permanent separation between vehicles and people.

    Perimeter Fixed Bollards

    Full perimeter fixed bollard installations around buildings, patios, and outdoor spaces requiring continuous vehicle barrier protection.

    Utility & Equipment Guards

    Fixed bollards protecting HVAC units, gas meters, electrical panels, and other ground-level equipment from vehicle damage.

    Pedestrian Zone Bollards

    Permanent bollard lines defining pedestrian-only zones in parking lots, loading areas, and mixed-use commercial properties.

    Drive-Through Lane Guards

    Fixed bollards at bank drive-throughs, pharmacy windows, and service lanes preventing vehicles from striking the building.

    Free Tool · 60 Seconds

    Not sure how many bollards you need?

    Try our free Bollard Calculator — answer 6 quick questions and get a tailored recommendation: bollard count, diameter, spacing, foundation, finish, and excavation method. Built for Alberta commercial sites.

    Most users finish in under a minute.
    Open Calculator

    "We needed bollards that would be there permanently — no moving parts, no maintenance schedule. Titan installed 12 fixed bollards in a single day and the site was clean by afternoon."

    — Property Manager, Calgary

    Everything's Handled

    One Crew. One Day. Permanent Protection.

    Every fixed bollard installation includes utility locates, core drilling or excavation, concrete footing preparation, bollard placement, anchoring, surface restoration, and full site cleanup. There are no subcontractors, no separate concrete crews, and no follow-up visits required.

    We handle the entire project from free site assessment to final walkthrough — including photo documentation uploaded to our CRM so you have a permanent record of your installation with images, locate certificates, and job specifications.

    Fixed bollards are the simplest bollard type to maintain: once installed, they require zero ongoing maintenance beyond occasional repainting if aesthetics are a priority.

    Why Choose Titan

    Built Different

    Free
    Site Assessment

    Every project starts with a no-cost evaluation of your property's layout, traffic, and risk zones.

    AB
    Province-Wide

    Fixed bollard installation across Edmonton, Calgary, Red Deer, Lethbridge, and all Alberta communities.

    #1
    Most Popular

    Fixed bollards are the most commonly installed bollard type for commercial properties in Alberta.

    Fast
    1-Day Install

    Most fixed bollard projects are completed in a single day — scheduled around your business operations.

    -40°C
    Winter Rated

    Galvanized steel and deep footings engineered for Alberta's extreme temperature swings and freeze-thaw cycles.

    YEG
    Edmonton Based

    Headquartered in Edmonton with crews ready to deploy across Alberta on short notice.

    Why It Matters

    Why Fixed Bollards Are Alberta's Default Choice

    Fixed bollards dominate Alberta's commercial landscape because they deliver permanent vehicle-stopping protection at the lowest per-unit cost of any bollard type. With no moving parts, no locking mechanisms, and no mechanical components, fixed bollards eliminate the maintenance burden and failure points associated with removable or retractable alternatives. For commercial bollard installations in Edmonton and Calgary, fixed bollards are the right answer for 99% of applications — from storefront protection to parking lot vehicle barriers.

    Lowest Cost Per Unit

    No moving parts or mechanisms means fixed bollards offer the best protection-to-price ratio of any bollard type.

    Zero Maintenance

    Once installed, fixed bollards require no servicing, lubrication, or mechanical upkeep — just occasional cosmetic touch-ups.

    Maximum Durability

    Galvanized steel embedded in deep concrete footings provides decades of corrosion-free, impact-ready performance.

    Built to Last

    Galvanized Steel — Always

    Every fixed bollard Titan installs uses hot-dip galvanized steel — not painted mild steel, not raw pipe, and never aluminium. Galvanization provides a permanent zinc coating that prevents corrosion from within, which is critical in Alberta where road salt, freeze-thaw cycles, and ground moisture attack unprotected steel year-round.

    We use Schedule 40 pipe for standard commercial applications and Schedule 80 for high-impact zones where vehicles approach at speed. The difference matters: Schedule 80 pipe has nearly 40% thicker walls than Schedule 40, delivering significantly more stopping force against vehicle impact.

    Our standard powder-coat finish is applied over the galvanization — not instead of it. This dual-layer approach means your bollards maintain their structural integrity even when the cosmetic finish chips or wears. Most competitors skip galvanization entirely to cut costs, leaving their bollards corroding from the inside within 3–5 years of installation.

    "We pulled out a competitor's bollard that was only four years old — the inside was completely rusted through. Not galvanized. Titan's bollards are galvanized every single time."

    — Titan Barriers Installation Crew Lead

    The Titan Standard

    If the Price Seems Too Good — It Probably Is

    Depth Matters — 12 Inches Won't Stop a Vehicle

    Many contractors install bollards only 12–16 inches deep to save time and concrete costs. At that depth, a bollard will snap, lean, or pull out of the ground on vehicle impact — offering zero real protection. Every Titan fixed bollard is set in concrete footings 42–48 inches deep, engineered to physically stop a moving vehicle. If your installer isn't digging to at least 42 inches, you're paying for a post — not a barrier. This shortcuts creates serious liability exposure and will likely fail an insurance inspection.

    6-Inch Diameter Is the Standard — Not 3-Inch Pipe

    Cheap bollard installations often use 3-inch or 4-inch thin-wall pipe that costs a fraction of proper materials. These undersized bollards bend or shear on impact — they look like bollards but perform like fence posts. Titan recommends 6-inch diameter Schedule 40 steel as the standard for commercial bollard installations. For high-impact zones, we use Schedule 80 with nearly 40% thicker walls. If your quote doesn't specify pipe diameter and schedule, ask — because the answer will tell you everything about the quality you're getting.

    Cutting Corners Creates Liability — Not Savings

    A bollard installed too shallow, with undersized pipe, or without proper galvanization isn't just a bad investment — it's a liability. If that bollard fails during a vehicle incident and someone is injured, the property owner is exposed. Insurance companies, municipal inspectors, and security assessments all look at installation depth, pipe specifications, and footing quality. A $200 bollard installed improperly can lead to property damage, personal injury claims, and voided insurance coverage. The cost difference between a proper installation and a cheap one is small — the liability difference is enormous.

    Material Specifications

    Specifications & Materials

    Galvanized SteelSchedule 40 / 804", 6", 8" Diameter42–48" FootingsPowder CoatedPermanent Embed350+ ColoursAlberta Climate Rated

    Full Transparency

    By the Numbers

    $400+
    Per Bollard

    Fixed bollards start at $400 per unit — but the more you install, the lower the per-unit cost as concrete truck and hydrovac costs are spread across more units.

    0
    Maintenance

    Fixed bollards have zero moving parts and require no ongoing servicing or mechanical upkeep.

    42–48"
    Footing Depth

    Every fixed bollard is set in concrete footings 42–48 inches deep for maximum vehicle-stopping force.

    25+ yrs
    Service Life

    Galvanized steel construction provides 25+ years of corrosion-free performance in Alberta's climate.

    1 Day
    Most Projects

    The majority of fixed bollard installations are completed in a single day with full site cleanup.

    100%
    Galvanized

    Every fixed bollard Titan installs is hot-dip galvanized — no exceptions, no shortcuts.

    Investment Guide

    Fixed Bollards Cost

    $400–$600

    per unit

    4" fixed bollards — ideal for pedestrian zones, walkways, and light commercial applications

    $600–$900

    per unit

    6" fixed bollards — the standard for storefront protection and entrance security

    $900–$1,250+

    per unit

    8" heavy-duty fixed bollards — maximum stopping force for high-risk zones

    All prices include supply, installation, concrete footings, and site cleanup. The more bollards in a project, the lower the per-unit cost — base costs like concrete truck delivery and hydrovac excavation are spread across more units. A 4-bollard project will cost significantly more per bollard than an 18-bollard project. Contact us for a free, detailed estimate.

    The Titan Advantage

    Built to Last in Alberta's Toughest Conditions

    Alberta's freeze-thaw cycles, heavy snowfall, and extreme temperature swings demand bollards engineered for durability. Every Titan Barriers installation uses galvanized steel, deep-set concrete footings, and professional anchoring to ensure your bollards perform year after year.

    Niche Expertise

    We install bollards every day — not as a sideline to general construction. Fixed bollards are our core business.

    Always Galvanized

    Hot-dip galvanized steel on every project. We never cut corners with painted mild steel or raw pipe.

    CRM Documentation

    Every installation is photographed and documented in our CRM — images, locates, specs, and job details accessible anytime.

    "Titan Barriers installed bollards around our entire warehouse facility. Professional crew, clean work, and done ahead of schedule. Couldn't be happier."

    Mark R.

    Facility Manager, Edmonton

    What You Get

    Key Benefits

    Permanent vehicle-stopping protection with no moving parts

    Lowest per-unit cost of any bollard type

    Zero ongoing maintenance requirements

    Galvanized steel resists Alberta's harsh climate for decades

    Available in 4", 6", and 8" diameters for any application

    350+ powder-coat colours to match any building or brand

    Our Process

    From Quote to Completion

    A clear, professional process from first contact to finished installation.

    Step 01

    Site Assessment

    Evaluate traffic flow, risk zones, and utility locations.

    Step 02

    Layout & Spacing

    Determine bollard diameter, spacing, and depth for your site.

    Step 03

    Installation

    Core drill, set footings, and install bollards in one visit.

    Step 04

    Cleanup & Handoff

    Restore surfaces, photograph, and walk through with you.

    Our Approach

    Built on Practical Experience

    No two sites are the same. We take the time to understand your layout, risks, and goals before recommending a solution.

    Fixed bollards are our most-installed product — we know them inside out
    Every bollard is galvanized before powder coating — no shortcuts
    One crew handles your entire project from assessment to cleanup
    CRM documentation with photos, locates, and specs for every job

    Common Questions

    Fixed Bollards FAQ

    Need Fixed Bollards Installed?

    Get a free estimate for fixed bollard installation in Edmonton, Calgary, Red Deer, or Lethbridge. Professional installation by Titan Barriers — Alberta's dedicated bollard experts.

    Already a customer? Leave us a Google review

    Get a Free Quote